Team Travis maintainers take the lead with 3D printed aircraft parts

U.S. Air Force Staff Sgt. Leander Monte, 60th Maintenance Squadron metals technology specialist, prepares to install a 3D printed floor panel that goes inside of the lavatory in a C-17 Globemaster III at Travis Air Force Base, California, Nov. 29, 2023. The 3D printed lavatory floor panel was designed and printed by the 60th MXS aircraft metals technology section; it is a direct replacement to the original part, which is no longer available for procurement. (U.S. Air Force photo by Senior Airman Alexander Merchak)

PHOTO BY: Senior Airman Alexander Merchak
VIRIN: 231129-F-YT028-1033.JPG
FULL SIZE: 5.74 MB
Additional Details

CAMERA

NIKON Z 7

LENS

24.0-70.0 mm f/2.8

APERTURE

28/10

SHUTTERSPEED

1/125

ISO

800

IMAGE IS PUBLIC DOMAIN

Read More

This photograph is considered public domain and has been cleared for release. If you would like to republish please give the photographer appropriate credit. Further, any commercial or non-commercial use of this photograph or any other DoD image must be made in compliance with guidance found at https://www.dimoc.mil/resources/limitations, which pertains to intellectual property restrictions (e.g., copyright and trademark, including the use of official emblems, insignia, names and slogans), warnings regarding use of images of identifiable personnel, appearance of endorsement, and related matters.